What kind of hairstyles are out of fashion from time to time. Sometimes you can be really surprised when you meet passers-by on the street, who, of course, are in trend, but they look rather strange. Recently, people are increasingly starting to shave their whiskey to match fashion trends. And if earlier
such a shocking act was typical only for representatives of informal youth cultures, today this hairstyle is considered a very glamorous attribute of the club style. In this image, you will not go unnoticed even in a crowd of bright personalities. However, whiskey must be shaved according to the rules. Otherwise, the hairstyle may turn out completely different from what was originally intended.
Precise movements
Be sure to practice properly holding the instrument with which you are going to perform this rather difficult procedure. If you chose a straight razor, then the correct grip with your fingersguarantees excellent results. Place three of them (index, ring and middle) directly on the neck of the instrument, and the large one on its lower part. The little finger should be exactly in the area of \u200b\u200bthe tail notch. Only in this case, shaved weights will cause envy, and not malicious laughter. The thumb should rest firmly on the heel of the instrument. Keep the razor point down. Stock up on a sufficient amount of foam in advance. It will make the procedure as comfortable and painless as possible, and will also significantly reduce the effect
rubbing against the skin. As a result, you will do without irritation and redness. Also pay attention to the sharpening of the tool. You can shave whiskey only if it is done correctly. Do not use a blunt tool either. In this case, there is a risk of injuring the skin.
Important preparation
Never use a dry shaving brush. It must be immersed in a container of hot water for some time in advance. As a result, the bristles will soften and will not scratch the skin. Let the water drain a little. After that, it will be possible to proceed further. Now there is no longer a special need to independently prepare the foam solution. In almost any supermarket you can buy a whole bottle at a reasonable price. However, it has long been noticed that shaving the face will be cleaner if you consciously approach such an important process. Therefore, for temples it is also worth choosing a good remedy. Whip the foam solution in a circular motion to
formed enough dense and thick air layer. It is he who will go into action.
The process itself
After the solution or foam is applied, you should immediately shave your temples. Otherwise, the skin may be exposed to the aggressive action of alkaline substances. To set the tool as accurately as possible, gently remove the layer of foam at the temple with the back of a razor. Then, pulling back the skin, begin to shave off the hair where you think it shouldn't be. You don't need to move your finger. Don't rush to avoid cutting yourself. When all the desired areas are thoroughly shaved, wipe off the remaining foam with a towel or paper towel and wash with cold water. Be sure to apply a special tool to the skin. It will prevent redness and also moisturize the skin.